Data Set Information
|
DATA_SET_NAME |
ROSETTA-ORBITER SW RPCMAG 2 PRL RAW V6.0
|
DATA_SET_ID |
RO-SS-RPCMAG-2-PRL-RAW-V6.0
|
NSSDC_DATA_SET_ID |
|
DATA_SET_TERSE_DESCRIPTION |
This dataset contains RPCMAG EDITED RAW DATA of the PRELANDING Phase.
Included are data 23.3.2014 - 21.11.2014.
|
DATA_SET_DESCRIPTION |
Data Set Overview
=================
The data from the ROSETTA PLASMA CONSORTIUM (RPC) Fluxgate
Magnetometer(MAG)was submitted by Ingo Richter (TM) for the RPCMAG
team. The PI of the team is Karl-Heinz Glassmeier.
The data have been measured during the PRELANDING Phase of ROSETTA.
Included are the following sub-phases:
-the Rendezvous Manoeuvre 2 (RVM2) between January and September 2014
-the Post Hibernation Commissioning in March/April 2014
-the Near Comet Drift Phase (NCD) between March and July 2014
-the Far Approach Trajectory (FAT)between July and August 2014
-the Comet Characterization Phase (CC) between August and September
-the Global Mapping Phase/Close Observation Phase (GMP/COP) between
September and October 2014
-the Landing and First Science Sequence (LD/FSS) between October and
November 2014
The several Landings of PHILAE happened on November 12, 2014.
All magnetic field data are edited raw data. That means the data
represent the 3 components of the magnetic field measured in counts of
the used 20 bit ADC. Data are given in instrument coordinates. Neither
any filtering nor any calibration has been applied to the data. Any
s/c generated noise and s/c caused residual magnetic fields are not
eliminated.
The data are sorted by the sensor (OB: outboard sensor, IB: inboard
sensor)and the measurement mode (M1..M6). They can uniquely be
identified by their file names.
Normally the OB is the Primary (Pri) and the IB is the Secondary (Sec)
sensor. However, this order can be toggled by TCs. This feature has
been tested especially during the commissioning phases.
In cases where the PRIMARY and SECONDARY sensor were toggled the
individual data files (OB/IB) will contain data measured with
different sampling rates according to the actual sampling rates of
the PRIMARY and SECONDARY sensors. Refer to the MODE DESCRIPTION
table below. The actual sampling rate is the only indicator
showing which sensor is the primary and which is the secondary
one.
REMARK ON TIMING
================
It turned out that the OB data are shifted against IB data and also
against ROMAP data by 1s. This behavior has not been corrected in the
data. Therefore, for proper comparison in high resolution analyses,
a time shift of 1s should be subtracted from all OB data.
Alternatively OB data can be left as they are and a 1s shift had to
be added to the IB and ROMAP data.
Mode description:
=================
MODE SAMPLE RATE PACKET PERIOD PACKET LENGTH VECTOR RATE
Minimum Mode M1 1/32 Hz 1024 s 32 Pri Vec 0.03125 vec/s
1 Sec Vec 0.000976 vec/s
Normal Mode M2 1 Hz 32 s 32 Pri Vec 1 vec/s
1 Sec Vec 0.03125 vec/s
Burst Mode M3 20 Hz 16 s 320 Pri Vec 20 vec/s
16 Sec Vec 1 vec/s
Medium Mode M4 5 Hz 32 s 160 Pri Vec 5 vec/s
1 Sec Vec 0.03125 vec/s
Low Mode M5 0.25 Hz 128 s 32 Pri Vec 0.25 vec/s
1 Sec Vec 0.007812 vec/s
Test Mode M6 20 Hz 16 s 320 Pri Vec 20 vec/s
1 Sec Vec 0.0625 vec/s
HK Mode 32 s 8 words 0.03125 vec/s
The HK mode contains coarse magnetic field information, measured by
the primary sensor with 16 bit resolution only. These data will not
be calibrated and are not used for any purpose.
FILENAME CONVENTION & Mode Coding
===================================
Due to operational constraints it might happen that the instrument
mode or the primary sensor has to be switched during a specific
observation.
The actual mode and the primary sensor of the instrument can easily
be identified by analyzing the filename of the actual data files. The
complete filename convention is listed in the EAICD, chapter 3.1.4.
The filenames for EDITED and CALIBRATED data are coded as follows:
___.
RPCMAG yymmddThhmm RAW IB M1..M6 LBL
CLA OB TAB
CLB
CLC
Example: RPCMAG040528T1230_RAW_OB_M3.LBL
RPCMAG040528T1230_RAW_OB_M3.TAB
The filenames for Housekeeping data are coded as follows:
_.
RPCMAG yymmddThhmm HK LBL
TAB
Example: RPCMAG040528T1230_HK.LBL
RPCMAG040528T1230_HK.TAB
Geometry Information - Coordinate System
========================================
The geometry items
SC_SUN_POSITION_VECTOR
SC_TARGET_POSITION_VECTOR
SC_TARGET_VELOCITY_VECTOR
provided in the label of the data product are relative to the
ECLIPJ2000 frame. This reference frame is built up by Ecliptic
Coordinates related to Equinox of Epoch J2000.
Orientation:
X: Pointing from SUN to Vernal Equinox,
Y: perpendicular to X in Ecliptic Plane,
Z: Perpendicular to Ecliptic plane, pointing up
The items
SUB_SPACECRAFT_LATITUDE
SUB_SPACECRAFT_LONGITUDE
are given in the PLANETOCENTRIC coordinate system.
All these geometry parameters are computed at time t=START_TIME.
Distances are given in km, angles in degrees.
Version Information
===================
The first version of RPCMAG datasets being archived for the comet
phase was V5.0. The actual version of this dataset is V6.0. The
version number had to be increased due to changes in houskeeping data
and quality flag changes.
|
DATA_SET_RELEASE_DATE |
2015-05-20T00:00:00.000Z
|
START_TIME |
2014-03-23T10:02:19.000Z
|
STOP_TIME |
2014-11-22T12:00:09.000Z
|
MISSION_NAME |
INTERNATIONAL ROSETTA MISSION
|
MISSION_START_DATE |
1995-03-01T12:00:00.000Z
|
MISSION_STOP_DATE |
N/A (ongoing)
|
TARGET_NAME |
CHECKOUT
67P/CHURYUMOV-GERASIMENKO 1 (1969 R1)
|
TARGET_TYPE |
UNKNOWN
COMET
|
INSTRUMENT_HOST_ID |
RO
|
INSTRUMENT_NAME |
ROSETTA PLASMA CONSORTIUM - FLUXGATE MAGNETOMETER
|
INSTRUMENT_ID |
RPCMAG
|
INSTRUMENT_TYPE |
MAGNETOMETER
|
NODE_NAME |
Small Bodies
|
ARCHIVE_STATUS |
SUPERSEDED
|
CONFIDENCE_LEVEL_NOTE |
This data set has the same structure as the
former RPCMAG datasets obtained between 2004
and 2011.
Those datasets have been reviewed by two
independent teams in Spring 2012. After these
reviews the datasets had been accepted by
the Planetary Science Archive(PSA) of the ESA
and by the Planetary Data System(PDS) of NASA
for long-term archiving.
A third review by european and US peers
took place in February 2016 and a fourth
review happened in October 2017.RPCMAG passed
these reviews very well with with only some
minor and editorial issues. All the required
updates and changes due to this review were
implemented in the present dataset.
All data have been processed on best effort
basis according to the procedures described
in RO-IGEP-TR0028: ''Step by Step Calibration
Procedure''. Quality flags are attached for
CALIBRATED and RESAMPLED data as described
in the EAICD RO-IGEP-TR0009. Both documents
are available in the DOCUMENT directory.
|
CITATION_DESCRIPTION |
Glassmeier K.-H., Richter I., Koenders C., Goetz C.,
Eichelberger. H, Cupido E.,
ROSETTA RPCMAG PRELANDING PHASE (PRL) EDITED RAW DATA RECORD V6.0,
RO-SS-RPCMAG-2-PRL-EDITED-V6.0, ESA Planetary Science Archive and
NASA Planetary Data System, 2016
|
ABSTRACT_TEXT |
This dataset contains EDITED RAW DATA (CODMAC LEVEL 2) of the
PRELANDING Phase (PRL) from March 23 until November 21, 2014 of the
ROSETTA orbiter magnetometer RPCMAG. Observations are done in the
vicinity of comet 67P/CHURYUMOV-GERASIMENKO 1 (1969 R1). The current
version of the dataset is V6.0
|
PRODUCER_FULL_NAME |
INGO RICHTER
|
SEARCH/ACCESS DATA |
SBN Comet Website
|